HP VCX Software 89

Chapter 6. Basic Conﬁguration

Network address

Shows the network address of the DNS Name Or Network Address you entered in the previous ﬁeld.

Netmask/Bits

Netmask/Bits is the mask that will be used to specify the conﬁguration computers. See chapter 3, Conﬁguring 3Com VCX IP Telecommuting Module, for instructions on writing the netmask. To limit access so that only one computer can conﬁgure, use the netmask 255.255.255.255. You can also specify the netmask as a number of bits, which in this case would be 32. To allow conﬁguration from an entire network, you must enter the network address under Network address, and a netmask with a lower number here. To allow conﬁg- uration from several computers or networks, create several lines for the information.

Range

The Range shows all IP addresses from which the Telecommuting Module can be conﬁg- ured. The range is calculated from the conﬁguration under DNS Name Or Network Address and Netmask/Bits. Check that the correct information was entered in the DNS Name Or Network Address and Netmask/Bits ﬁelds.

Via IPsec Peer

Here, you can select an IPsec Peer from which this connection must be made. If an IPsec peer is selected, you will only be able to conﬁgure the Telecommuting Module from this IP address through an IPsec tunnel.

SSH

Check the check box if this computer/network should be allowed to conﬁgure the Telecom- muting Module via SSH.

HTTP

Check the check box if this computer/network should be allowed to conﬁgure the Telecom- muting Module via HTTP.

HTTPS

Check the check box if this computer/network should be allowed to conﬁgure the Telecom- muting Module via HTTPS.

Log Class

Here, you enter what log class the Telecommuting Module should use to log the conﬁgura- tion trafﬁc to the Telecommuting Module’s web server. Log classes are deﬁned on the Log Classes page under Logging. See also the chapter titled Logging.