Chapter 7. Administration

Step 3

If Apply upgrade was pressed, the buttons Try the upgrade and Remove upgrade will appear.

Try the upgrade

Try the upgrade will reboot the Telecommuting Module and test the loaded upgrade. When the reboot is done, log on to continue upgrading the Telecommuting Module.

Remove upgrade

Remove upgrade removes the loaded upgrade from the Telecommuting Module. The up- grade will not be installed.

Step 4

When you have pressed Try the upgrade and the Telecommuting Module has rebooted, you will see two buttons on top of every web page: Accept upgrade and Abort upgrade.

Now, you can choose to make the upgrade permanent or to revert to the old version. You can check the configuration, but no changes can be done before the upgrade is permanent. If the Telecommuting Module is rebooted before the upgrade is made permanent, it will revert to the old version.

Accept upgrade

Accept upgrade will complete the upgrade. When you have accepted the upgrade, you must also go to Save/Load Configuration and Apply configuration, i. e. the new upgrade.

Abort upgrade

Abort upgrade aborts the upgrade. The Telecommuting Module will revert to the old ver- sion.

Downgrade

If the Telecommuting Module has been upgraded before, it is possible to downgrade to the previous version.

When you downgrade, the Telecommuting Module will revert to the configuration it had before upgrading. All configuration changes made after the upgrade will be lost.

When you want to upgrade, the upgrade file must be uploaded again.

Table Look

There are two alternatives for tables in 3Com VCX IP Telecommuting Module: Either you can change the contents of the table directly, or else you must click on a box in the Edit Row column to allow the row to be changed. The image below shows how tables with an Edit Row column can look.

111

Page 119
Image 119
HP VCX Software manual Table Look, Downgrade, Try the upgrade, Accept upgrade, Abort upgrade