Chapter 15. Command Line Reference
Apply a configuration
You can use CLI commands to apply the changed settings. Note that you need to perform approximately the same steps as when you apply in the web GUI; first start a test run (cor- responds to pressing the Apply configuration button in the web GUI), and then confirm it (corresponds to pressing the Save configuration button on the test run page). If you need to test the new configuration for a longer period than you originally set as the test mode dura- tion, you can enter a command to extend the test run (corresponds to pressing the Continue test run button on the test run page).
This command sequence will start a test run with a test mode duration of 200 seconds, then extend the test run and finally confirm it.
318