IBM 1422 manual Power Saver, Timeout, 240

Understanding the operator panel

Menu item	Purpose	Values
Power Saver	To specify the amount of time (in	Disabled	This value does not appear unless
	minutes) the printer waits after a		Energy Conserve is set to Off.
	job is printed before it goes into a
		1...240	Specifies the amount of time after
	reduced power state.
			a print job before the printer goes
			into Power Saver mode. (Your
			printer may not support the entire
			range of values.)
			The factory default Power Saver
			setting depends on your printer
			model. Print the menu settings
			page to determine the current
			Power Saver setting. When the
			printer is in Power Saver mode, it
			is still ready to receive print jobs.
			Select 1 to put the printer in Power
			Saver mode one minute after it
			finishes a print job. This uses
			much less energy, but requires
			more warm-up time for the printer.
			Select 1 if your printer shares an
			electrical circuit with room lighting
			and you notice lights flickering.
			Select a high value if your printer is
			in constant use. Under most
			circumstances, this keeps the
			printer ready to print with minimum
			warm-up time. Select a value
			between 1 and 240 minutes if you
			want a balance between energy
			consumption and a shorter warm-
			up period.
Print	To specify the amount of time (in	Disabled	The printer does not print the last
Timeout	seconds) the printer waits before		page of a print job until one of the
	printing the last page of a print job		following occurs:
	that does not end with a command		• The printer receives enough
	to print the page. The print timeout
			information to fill the page.
	counter does not start until
			• The printer receives a Form
	Waiting is displayed.
			Feed command.
			• You select Print Buffer from the
			Job Menu.
		1...255 (90*)	The printer prints the last page
			after the specified time. (Your
			printer may not support the entire
			range of values.)

Using the printer menus

88