IBM 51 manual StopServer server1 startServer server1

assign a different port to the administrative console. You can do this when you install WebSphere Application Server or afterwards.

To change the port used by the WebSphere Administrative Console after WebSphere Application Server is installed, complete the following steps. In this example, the WebSphere Administrative Console runs under the application server named server1 and the Web browser is running on the same system as WebSphere Application Server:

1.Select an available port using both of the following techniques:

v Examine the /etc/services or %SYSTEMROOT%\System32\drivers\etc\services file to see a list of port definitions for the system.

The list includes ports that can be used by services on your system, even if the port is not currently in use. The file does not include ports that are opened dynamically by applications.

vUse the netstat -a command to list the active ports on this system. This example uses port 9091.

2.In the virtualhosts.xml file, located in the

WAS_install_dir/config/cells/cellName directory, change port 9090 to 9091.

3.In the server.xml file, located in the

WAS_install_dir/config/cells/cellName/nodes/nodeName/server/server1 directory, change port 9090 to 9091.

4.Stop server1, and then start it using the following commands:

stopServer server1 startServer server1

5.Access the administrative console using the following Web address: http://hostName:9091/admin

On Windows, if you have shortcuts to the administrative console, you must change the port number in the Target field of the shortcut properties.

If this chapter did not help you resolve your problem, you can get additional assistance from the IBM Software Support Web site at the following Web address:

http://www.ibm.com/software/support/

Chapter 8. Troubleshooting the agent manager 89