SECTION 4

Maintenance and Troubleshooting

 

 

Table 4-1 continued

 

 

Basic Troubleshooting

Condition

 

Solution

 

 

 

 

A Fully Charged

 

Leave the same battery pack in your computer for at least

Battery Pack In

 

30 minutes, to allow some time to put some charge into

The Computer

 

your backup battery. Then replace the battery pack with a

Still Does Not

 

fully charged pack. Put the original battery pack into an

Bring It To Life.

 

external battery charger.

None Of The LEDs

 

 

Light On The

 

 

Battery Pack.

 

 

 

 

 

The LEDs On The

 

It takes a minute after you put in the battery pack for your

Battery Pack Do

 

computer to check the status and display the updated

Not Match the

 

battery charge level.

LEDs On The

 

 

Display

 

 

 

 

 

After A Weekend A

 

The computer was left for the weekend without a battery

Fully Charged

 

pack in it. Therefore, when you start out the week with the

Battery Pack Does

 

fresh charged battery it has to build up the charge level in

Not Last The

 

the backup battery and that leaves less power for its

Normal Length Of

 

normal days use.

Time

 

 

 

 

 

Computer Reboots

 

The computer was not suspended (pressing the [I/O] key to

When A Battery

 

blank the display) before the battery was replaced.

Pack Is Installed

 

Another reason can be that the backup battery may be

 

 

 

 

drained. Recharge the computer for a minimum of 12 hours.

 

 

If a problem still exists then send your computer to the

 

 

service center.

 

 

 

Putting The

 

There is a fault state condition occurring in the battery

Computer Into A

 

pack or the charger. For the complete details concerning

Charging Device

 

the sequence of the colors of the blinks refer to Section 2

The Charge LED

 

Battery Charger LED and Error Codes on page 2-10.

Blinks Different

 

 

Colors

 

 

 

 

 

6400 Hand-Held Computer User’s Guide 4-5

Page 141
Image 141
Intermec 6400 manual Basic Troubleshooting