Maintenance and Troubleshooting | SECTION 4 |
|
| Table |
|
| Basic Troubleshooting |
Condition |
| Solution |
| ||
|
|
|
When Putting The |
| There is a fault state condition occurring in the battery |
Battery Pack In |
| pack or the charger. For the complete details concerning |
The Charger The |
| the sequence of the colors of the blinks refer to Section 2 |
LED Never Turns |
| Battery Charger LED and Error Codes on page |
Green |
|
|
|
|
|
Computer Does |
| * Ensure that there is a main battery in. |
Not Turn ON When |
| * Ensure that the main battery is charged. |
The [I/O] Key Is |
| * Ensure that the battery compartment door is closed. |
Pressed |
| |
|
| |
|
|
|
Computer Does |
| * Ensure the dock is plugged in. |
Not Turn ON When |
| * Ensure that the battery compartment door is closed. |
Placed In A Dock |
| * Reseat computer into dock to ensure proper connection. |
|
| |
|
|
|
Computer Shuts |
| * You may have a very low battery. Try recharging the main |
Down During Use |
| battery. |
|
| * You may have hit the battery door latch; this causes your |
|
| computer to suspend. Check the latch then press the [I/O] |
|
| key to continue operation. |
|
|
|
Computer Resets |
| The backup battery may not be fully charged, allow at least |
When You Replace |
| 8 hours to completely recharge the backup battery. |
Or Check The |
|
|
Main Battery |
|
|
|
|
|
Computer Turns |
| This is the correct operation, the unit shuts down to |
OFF When You |
| conserve energy and save data. |
Open The Battery |
|
|
Door Latch |
|
|
|
|
|
Computer Does |
| * The computer stays on when it is connected to a charging |
Not Suspend |
| device. |
|
| * The computer stays on when it is processing data or in |
|
| radio communications. |
|
| This is OK if connected to a charger or placed in a dock. If |
|
| this is not the case, and either of these conditions continues |
|
| for a long period of time, contact Intermec support |
|
| personnel, as this condition runs down the batteries. |
|
|
|