Terminal Emulation Menu Screens

SECTION 3

Bar Code Parms

The Bar Code Parms (parameters) menus designate:

"If you are using a bar code scanner

"Scan options

"The bar code symbologies to use (the computer can only decode the bar code symbologies you enable)

"Options for each enabled bar code symbology (e.g., minimum and maximum bar code lengths)

The Scanner Type menu is the first Bar Code Parms menu. Choose the desired option from this menu and press the [ENT] key. The next Bar Code Parms menu appears on the display.

Scanner Type

Use the Scanner Type menu to designate the type of bar code scanner.

Scanner Type

1)No Scanner

3)Laser

To make a selection, press the numeric key corresponding to the desired option, then press the [ENT] key. This takes you to the Scan Options menu.

"NOTE: You can choose option 1, “No Scanner,” and still set the remaining scanner and bar code options. Then, if you use a scanner at a later time, all parameters are set and it is only necessary to designate the scanner type.

"NOTE: Selected options are highlighted on the display. To deselect a se- lected option, press the key that corresponds to that option.

3-186400 Hand-Held Computer User’s Guide

Page 90
Image 90
Intermec 6400 manual Bar Code Parms