Intermec 6400 manual Setting Terminal Emulation to Accept Tethered Laser Scanners

Operation SECTION 2

stop bit with an ASCII STX (hex 02) before the data and an ASCII ETX (hex 03) after the data. No protocols, such as ACK/NAK, RTS/CTS, or XON/XOFF, are supported. All

8-bit characters between the STX and ETX will be stuffed in the PC BIOS key buffer.

Setting Terminal Emulation to

Accept Tethered Laser Scanners

1.In AUTOEXEC.BAT, ensure the scanner driver is loaded with 64SCN7B --T1 --I0

2.From the Terminal Emulation mode, press the yellow and then the blue keys to enter the Terminal Emula- tion Main Menu.

3.Select option 1) Set-up Parms.

4.Enter password CR52401.

5.Select option 2) Barcode Parms.

6.At Scanner Type menu select 3) Laser and press [ENT] five times.

7.At Main Menu select 4) Tests

8.At Tests menu select 1) Peripherals

9.At Peripherals menu select 5) Scanner Test

If you experience problems with using your laser scanner with terminal emulation try these steps:

1.Reboot to the DOS prompt ([YELLOW] [BLUE] [ENT] [ENT]) press 0 at pause.

2.Type DEL CONFIG.DAT press [ENT].

3.Press [CTRL] [ALT] [DEL] to reboot.

2-206400 Hand-Held Computer User’s Guide