10/100
BASE T
CONSOLE
Figure C-1SRP I/O module serial port
Table C-2lists the pinout for the serial cable’s RS-232 connector.
Table C-1SRP I/O module – RS-232 serial connector pinout
Pin | Signal |
1 | DCD |
| |
2 | RXD |
| |
3 | TXD |
| |
4 | DTR |
| |
5 | GND |
| |
6 | DSR |
| |
7 | RTS |
| |
8 | CTS |
| |
9 | RNG |
| |
Once you have configured an IP address on the system, you can connect a console running Telnet to the 10/100Base-T Ethernet port on the SRP I/O module. The system ships with a straight-through cable having a male RJ-45 Ethernet connector on each end. Figure C-2shows the location of the Ethernet port and the sequence of the pins in the RJ-45 connector.
