Installing SRP I/O and SRP Modules
ERX Edge Routers
3-7
Figure 3-5 Removing the blank faceplate
Caution: Always handle the module by its edges. Do not touch the components,
pins, leads, or solder connections.
4Remove the SRP I/O module from its antistatic bag.
5Position the module as follows:
•For the ERX-1400 series, position the module vertically so that
the labeling is upright.
•For the ERX-700 series, position the module horizontally so that
the alarm leads are to the right.
6Position the module into the chassis by placing it between the guides
of the selected slot, and slide the module until it stops.
Figure 3-6 shows how to install an SRP I/O module in the ERX-1400
series.
counterclockwise