CHAPTER 7
Maintaining the ERX System
7-4
6When this SRP module is available, synchronize the SRP modules.
host1#synchronize
7When the SRP modules are synchronized, reboot the SRP module
that you upgraded.
host1#reload slot 6
8When this SRP module is available, synchronize the SRP modules.
host1#synchronize
9When the SRP modules are synchronized, force the redundant SRP
module to take over from the primary SRP module.
host1#srp switch
10 Immediately remove the former primary SRP module.
11 Repeat steps 4–8 for the fo rmer prima ry SRP modu le.
Replacing an NVS Card
To replace an NVS card on an SRP module:
1Obtain an antistatic container for the NVS card you will remove (see
Storing Modules and Components, earlier in this chapter).
2With a small flathead screwdriver, remove the faceplate from the
NVS card slot on the SRP module (see Figure7-1).
3Use the screwdriver to depress the button next to the NVS card (see
Figure 7-1).
This action releases the NVS card.