
Chapter 5---Electronics
when the
Quad Standard Decoder VIC - Service Adjustments
There are no physical service adjustments to the Quad Standard Decoder VIC.
Quad Standard Decoder VIC - Remove and Replace
Tools Needed
#0
Parts Needed
Quad Standard Decoder VIC p/n 103545
To remove the Quad Standard Decoder VIC:
1.Power off the projector by IR Remote or PC, and allow the cooling fans to run until they shut off automatically.
2.Turn the AC Circuit Breaker to the OFF position and unplug the AC Power Cord.
3.It is not necessary to remove the rear cover.
4.Disconnect the input BNC cables from the VIC.
5.Remove the two retaining screws from the faceplate of the VIC.
6.Pull the VIC out of the Electronics Module.
7.Reverse the process to install the VIC.
Quad Standard Decoder/Line Doubler VIC
The Quad Standard Decoder/Line Doubler VIC is very similar in function to the Quad Standard Decoder VIC. It accepts the same two source input formats, Composite and
The Line Doubler section doubles the horizontal scan frequency of the input source. As an example, if the input source is a Composite signal in NTSC, which has a line rate of about 15 .75 kHz, the Quad Standard Decoder/Line Doubler VIC doubles the line rate to 31.5 kHz. This provides a much cleaner display on the screen.
The Quad Standard Decoder/Line Doubler VIC takes two VIC slots, even though the faceplate only covers on space. Some of the components prevent it from fitting into one VIC slot. When the Quad Standard Decoder/Line Doubler VIC is
Model 250 Service Manual |