
Chapter 5---Electronics
The Video Amplifier PCB detects all the necessary supply voltages (+80 V, +15 V, and the +6.2 V) for the CRT and includes that as part of the /VA_OK signal. If any of the supply voltages is not present, /VA_OK goes high, again shutting down the G1 and G2 regulators. The /VA_OK goes out to the High Voltage Power Supply as the /HV_ENA. If the /VA_OK goes high, the /HV_ENA goes high and shuts down the high voltage amplifier section of the High Voltage Power Supply (see CRT Protection section of the Ch
The CRT Protection circuit on the Video Amplifier PCB also has a beam current sense line for each CRT that comes from the output of the image amplifier circuit. It samples each CRT beam current and sends that back to the Video Processor PCB. The Video Processor PCB compares the beam current to a reference value (250 µA). If the beam current of any CRT meets or exceeds that reference value, the Video Amplifier PCB reduces the Contrast of the CRTs (a global adjustment) until the beam current is below the reference.
The CRT Protection circuit also provides isolation of the anode voltage return through the Arc Ground circuit. Occasionally, particles flake off metal components inside CRTs that cause shorting inside the CRT. On these occasions, the Arc Ground circuit is an isolated ground path back to the High Voltage Power Supply. This isolation protects the other supply voltage returns.
The Video Amplifier PCB has three CRT Socket PCBs that are attached to the back of each CRT. These PCBs provide an interface between the Video Amplifier PCB and the CRT for the image signal, G1, G2, and filament voltages (see Figure
Video Amplifier PCB - Remove and Replace
The Video Amplifier PCB is located under the CRT assemblies at the rear of the projector.
Tools Needed
#1
Parts Needed
Video Amplifier PCB p/n 105232
To remove a Video Amplifier PCB:
1.Power off the projector by IR Remote or PC, and allow the cooling fans to run until they shut off automatically.
2.Turn the AC Circuit Breaker to the OFF position and unplug the AC Power Cord.
3.Remove the rear cover.
4.Tilt the Electronic Module up.
Model 250 Service Manual |