JVC 250 service manual Communications Protocol

Chapter 8---Software and Protocol

Communications Protocol

Select SETTINGS using the menu bar, then select COMMUNICATIONS. Set the following communications parameters and modes.

Table 8-2	Communications settings
Baud Rate		9600	Stop Bits	1
Data Bits		8	Flow Control	Xon/Xoff
Parity		None	Carrier Detect	No
Parity Check		No
Connector		Com1-This is PC
		configuration
		dependent.

Select FILE from the menu bar and select NEW. Under File Name enter VT- 100.TRM. This will allow the user to select the file VT-100.TRM with the above parameters saved for future use.

Table 8-3VT-100 Terminal and Remote Command Equivalents

Action	Keyboard	Executive	Service	Dec.	Hex.
	Input	Remote Keys	Remote Keys
Power OFF	CTRL + F			6	6
(All)
Power ON (All)	CTRL + U			21	15
Power ON/OFF	CTRL-P	POWER	POWER	16	10
Power	CTRL + E			5	5
ON/OFF-
Electronics only
Power ON/OFF	CTRL + L			12	0C
Lamp
Left Arrow	Left Arrow	Left Arrow	Left Arrow	27 91	1B 5B
				68*	44*
Right Arrow	Right Arrow	Right Arrow	Right Arrow	27 91	1B 5B
				67*	43*
Up Arrow	Up Arrow	Up Arrow	Up Arrow	27 91	1B 5B
				65*	41*
Down Arrow	Down Arrow	Down Arrow	Down Arrow	27 91	1B 5B
				66*	42*
Back out of	Esc	ESC	ESC	27	1B
menu
Blanking	B		BLANK	66	42
Bow, H & V	U		BOW	85	55
Brightness	I	BRT	BRT	73	49

Model 250 Service Manual 8-11