KitchenAid 4KFP750 manual Preparing the Food Processor for Use, Cut Hazard Handle blades carefully

Preparing the Food Processor for Use

WARNING

Cut Hazard

Handle blades carefully.

Failure to do so can result in cuts.

Before First Use

Before using your Food Processor for the first time, wash the work bowl, work bowl cover, mini bowl, feed tube pusher, discs, and blades either by hand or in the dishwasher (see “Cleaning the Food Processor” on page 12).

Work Bowl Assembly

1.Place the Food Processor base on a dry, level countertop with the controls facing forward. Do not plug in the unit until it is completely assembled.

2.With the handle just to the left of center, place the work bowl on the base, fitting the center opening over the power shaft.

3.Grasp the work bowl handle and turn the bowl to the right until it locks into position.

4.Insert the desired accessory into the work bowl. See pages 9–10 for accessory instructions.

5.Place the work bowl cover on the work bowl with the feed tube just to the left of the work bowl handle. Grasp the feed tube and turn the cover to the right until it locks into place.

NOTE: Do not attach the cover to the work bowl before the work bowl is locked on the base. Damage to the work bowl may result.

6.Fit the 2-piece food pusher into the feed tube.

Off

On

Pulse

7.Plug into a proper electrical outlet. NOTE: Your Food Processor will not operate unless the work bowl and work bowl cover are properly locked on the base.

Do not remove the work bowl from the base without first removing the work bowl cover. Damage to the work bowl may result.

8