4 | Press the U or V key repeatedly until Serial | ||||
| appears. | ||||
|
|
|
|
|
|
|
|
|
| Interface |
|
|
|
|
| ||
|
| ? Serial |
| ||
5 |
|
|
|
|
|
|
|
|
|
| |
Press the ENTER key again. | |||||
6 | Press the Z key. One of the following serial | ||||
| parameters is indicated (Baud rate for example). | ||||
Pressing the U or V key toggles through the serial parameters as follows. To change the serial parameter, press the ENTER key. Use the U or V key to change the value or selection.
3.5 Changing the Interface Parameters
Press the U or V key to scroll through values. When 115200 is displayed, press the ENTER key. Press the MODE key to exit the menu selection.
| Some computers may not be able to handle a |
| baud rate of 115200 bps. If you set the baud |
Note | rate to 115200 and encounter communication |
| problems, select a lower baud rate. |
3.5.3Changing Network Interface Parameters
The printer has a
>Baud Rate 9600
>Data Bits 8
>Stop Bits 1
>Parity None
>Protocol
DTR(pos.)&XON
Range
1200, 2400, 4800,
9600 (Default),
19200, 38400,
57600, 115200
7 or 8 (Default)
1 (Default) or 2
None (Default), Odd, Even, or Ignore
DTR (pos.) &
Xon (Default), DTR
(positive), DTR (nega-
tive), XON/XOFF,
ETX/ACK
To adjust the printer for networking parameters of the current network, using the operator panel, you can:
•Activate or deactivate TCP/IP, NetWare, and AppleTalk
•Activate or deactivate DHCP
•Enter IP address, subnet mask address, and default gateway address
•Determine whether to print a network status pages automatically when the printer is turned on
To confirm or change networking parameters, proceed as follows:
1 | Press the MENU key. |
|
| |||
2 | Press the U or V key repeatedly until Interface | |||||
| > appears. |
|
| |||
3 | If the current interface is other than network, press the | |||||
| ENTER key. A blinking question mark (?) appears. | |||||
|
|
|
|
|
|
|
|
|
|
| Interface | > |
|
|
|
|
| |||
|
|
| ? Parallel |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
If the optional network interface card is installed in the printer, Option will be displayed. The setting
For example, to change baud rate from 9600 to 115200, display the baud rate menu following the above procedure. When the display shows baud rate, 9600 (bps), press the ENTER key. A blinking question mark (?) appears.
>Baud Rate 
?
9600
procedure is basically the same even in this case.
4 | Press the U or V key repeatedly until Network | |||||
| appears. |
|
| |||
|
|
|
|
|
|
|
|
|
|
| Interface | > |
|
|
|
|
| |||
|
|
| ? Network |
|
| |
5 |
|
|
|
|
|
|
|
|
|
|
|
| |
Press the ENTER key again. | ||||||
