3.13 Other Modes
5 | Press the ENTER key. A blinking question mark (?) | 5 | Press the ENTER key. A blinking question mark (?) |
| appears. |
| appears. |
6
7
8
>Buzzer
? Off
Select On or Off using the U or V key.
Press the ENTER key.
To exit the menu selection, press the MENU key.
6
7
8
>Auto Continue
Mode ? Off
Select On or Off using the U or V key.
Press the ENTER key.
To exit the menu selection, press the MENU key. The display returns to Ready.
3.13.8Auto Continue Setting
When Auto Continue is enabled, the printer will automatically print the next received data following a preset amount of time passes after any one of the following errors occurs:
[Memory overflow Press GO] [Print overrun Press GO] [KPDL error Press GO] [File not found Press GO] [RAM disk error Press GO] [MemoryCard err Press GO] [Hard disk err Press GO] [Duplex disabled Press GO] [Add Staple Press GO] [Chad box full Press GO].
If one of the above errors is caused by someone on a network where the printer is being shared, for example, data sent from another person will be printed after a preset amount of time.
The default Auto Continue setting is Off (disabled).
For setting the auto continue recovery time, see the next section.
Note
1 | Press the MENU key. |
|
| |
2 | Press the U or V key repeatedly until Others > | |||
| appears. |
|
| |
|
|
|
|
|
|
| Others | > |
|
|
|
|
|
|
3 | Press the Z key | ||
4 | Press the U or V key repeatedly until Auto | ||
| Continue > appears. | ||
|
|
|
|
|
| >Auto Continue > |
|
|
| Mode Off |
|
|
|
|
|
3.13.9Setting the Auto Continue Recovery Time
Follow the procedure given below to change the recovery time for Auto Continue.
1 | Press the MENU key. | ||||
2 | Press the U or V key repeatedly until Others > | ||||
| appears. |
|
|
| |
|
|
|
|
|
|
|
| Others | > |
| |
3 |
|
|
|
| |
Press the Z key. | |||||
4 | Press the U or V key repeatedly until Auto | ||||
| Continue Mode > appears. | ||||
|
|
|
| ||
|
| >Auto Continue > |
| ||
|
| Mode | On |
| |
5 |
|
|
|
| |
Press the Z key and display >> Auto Continue | |||||
| Timer. The default setting is 30 seconds. | ||||
|
|
|
| ||
|
| >>Auto Continue |
| ||
|
| Timer | 030sec. |
| |
6 |
|
|
|
| |
Press the ENTER key. A blinking cursor (_) appears. | |||||
|
| >>Auto Continue |
| ||
|
| Timer |
|
|
|
|
| 030sec. |
| ||
|
|
|
|
|
|
