Lantronix MSS manual Change Access, Current port only

Command Reference Change Access

keydata

Enter the WEP key. The key format should be entered as “xx-xx-xx-xx...” where each x is a hexadecimal digit (0 through 9 and A through F). Each pair of hex digits (xx) defines a byte of key data, and each byte is separated from the next by a dash. For a 40-bit key, 5 bytes of key data must be given. For a 128-bit key, 13 bytes of data must be given.

Receive

Determines whether the MSS will receive unencrypted data while WEP is enabled.

All

Allows reception of encrypted traffic while WEP is enabled. The MSS will accept unencrypted wireless network frames, as well as frames encrypted with its WEP key. This is the default setting once WEP has been enabled.

Encrypted

Refuses to accept unencrypted data while WEP is enabled. The MSS will discard and ignore unencrypted wireless network frames, accepting only frames encrypted with its WEP key.

Defaults	Disabled, Receive all
Examples	Local>> CHANGE 80211 WEP ENABLED
	Local>> CHANGE 80211	WEP INDEX 3
	Local>> CHANGE 80211	WEP RECEIVE ENCRYPTED
	Local>> CHANGE 80211	RESET
See Also	Show 80211, page 2-63

2.3 Change Access

			LOCAL	
				
CHANGE	PORT PortList		DYNAMIC 
		ACCESS 		
			REMOTE 
			NONE	
				

Specifies which types of connections the specified serial port will accept.

Restrictions	Requires privileged user status.
	The None parameter is only valid for the MSS4.
	Autobaud must be disabled for ports set to Dynamic and Remote access.
Errors	If a port is active, its access can not be changed.
Parameters	Port
	MSS4 only. Specifies a particular port or group of ports.
Note:	In the absence of the Portlist parameter, the configuration will affect the MSS4’s
	current port only.

2-10