Lantronix Complete Guide to Configuring Your Network Card with MSS4

Environment Strings			Usage Examples
		Table B-1:Environment Strings
	R	Rlogin protocol (sets port number to 513 if not already set)
	T	TCP mode (raw uninterpreted data stream)
	U	UDP mode (the default UDP socket is 4096)
	S	Specifies session mode. Only valid with U.
	xxxx	Timeout value in seconds, up to 3600 (1 hour). Only valid
		with :S
	Y	Encrypted mode (raw TCP socket that encrypts all data
		using a 56-bit key)
	LD=port#	Sets the LAT destination port to port#
	LN=node#	Sets the target LAT node to node#

B.2.1 Usage Examples

These examples should illustrate the proper usage of the above environment strings.

2.2.1.1 nnnn

Sets a socket number. For TCP and UDP connections only. The most common socket numbers are 7000 (the MSS remote console port), 200x (for Telnet IAC interpretation), and 300x (for raw TCP/IP), where x is the number of the desired serial port.

Examples% telnet 192.0.1.88:7000

(connects to the remote console port of the specified host)

% telnet 192.0.1.66:3001

(forms a raw TCP/IP connection to the MSS serial console port)

Local> TELNET 192.0.1.45:2003

(forms a connection with Telnet IAC interpretation to the third serial port of an MSS4)

See Also Your MSS Installation Guide for more information on socket connections

2.2.1.2 +C and -C

+C specifies CR to CRLF. -C specifies CR to LF.

ExamplesLocal>> CHANGE PREFERRED TELNET 192.0.1.3:+C

2.2.1.3 +D and -D

+D sets Backspace mode. -D sets Delete mode.

Examples% telnet 192.0.1.5:-D

2.2.1.4 +E and -E

+E sets Local Echo mode. -E sets Remote Echo mode.

Examples% telnet 192.0.1.48:+E

B-2