Command Reference | Change Loginpass |
2.31 Change Loginpass
CHANGE SERVER LOGINPASS passwd
Specifies the password used to log into the MSS. The password should consist of no more than 6 alphabetic letters. Users are only required to provide this password if the port has Password Protect enabled.
If you do not enter the password at the command line, you will immediately be prompted to enter the new password. This password is not displayed when typed.
Restrictions | Requires privileged user status. |
Parameters | Server |
| MSS4 only. |
| passwd |
| Enter a password of up to 6 alphabetic characters. When entered as part of the |
| command, the password should be enclosed by quotation marks to preserve |
| case. |
Defaults | access |
Examples | CHANGE LOGINPASS “badger” |
See Also | Change Password Protect, page |
2.32 Change Modem Control
DISABLED
CHANGE PORT PortList MODEM CONTROL ENABLED
Causes the MSS to treat any attached serial device as a modem. When enabled, a DSR drop will log out the enabled port and the MSS will drop DTR for three seconds and then raise it when the port logs out. If Autostart is also enabled, the port will not start until DSR is raised. The MSS supports partial modem control (DSR/DTR).
Restrictions | Requires privileged user status. |
| Does not apply to the MSS485. |
Errors | Modem Control must be disabled to use DSRLogout. |
Parameters | Port |
| MSS4 only. Specifies a particular port or group of ports. |
Note: | In the absence of the PortList parameter, the configuration will affect the MSS4’s |
| current port only. |
