Lantronix MSS manual Change Stopbits, Change Subnet Mask, Defaults See Also

Command Reference	Change Stopbits
	num
	Specify the desired number or retry attempts. Enter zero to make the MSS retry
	until the startupfile is read (indefinitely).
Defaults	Retry: 5
Examples	Local> CHANGE STARTUP FILE “bob:start”
	Local> CHANGE STARTUP FILE hevax::start.com
	Local> CHANGE STARTUP FILE “engfs\sys:\login\start.cmd”
	Local> CHANGE SERVER STARTUP RETRY 6
See Also	Change Loadhost, page 2-29; Source, page 2-67.

2.60 Change Stopbits

CHANGE	PORT PortList		1	
		STOPBITS 		
			2 

Specifies how many stop bits the port will use.

Restrictions	Requires privileged user status.
Parameters	Port
	MSS4 only. Specifies a particular port or group of ports.
Note:	In the absence of the PortList parameter, the configuration will affect the MSS4’s
	current port only.
	PortList
	Specify a particular port or group of ports. Port numbers are specified with
	integers between 1 and 4, and should be separated with commas (for lists) or
	dashes (for ranges).
Defaults	1
See Also	Change Autobaud, page 2-11; Change Charsize, page 2-16; Change Parity,
	page 2-35.

2.61 Change Subnet Mask

CHANGE

SERVER

SUBNET MASK mask

Sets an IP subnet mask for the MSS. The mask is applied to target IP addresses to determine whether the destination address is on the local network segment. If the address is not on the local segment, the MSS’s gateway host will be accessed to provide the connection. A mask is created by default when the IP address is first set, but can be overridden with this command.

2-47