Command Reference | Change LAT CircTimer |
Restrictions | Requires privileged user status. |
| The Both, Incoming, and Outgoing parameters are only applicable to the |
| MSS4. |
Parameters | IPaddress |
| Specify an address in standard numeric format. An address with 0 or 255 in any |
| segment restricts all addresses in that range. |
| Both |
| MSS4 only. Restricts logins from the network into the server and TCP sessions |
| to the network from the server. |
| Incoming |
| MSS4 only. Restricts logins from the network into the server, and connections |
| to the serial port. |
| Outgoing |
| MSS4 only. Restricts TCP sessions to the network from the server. |
| Ports |
| MSS4 only. Specifies a particular port or group of ports. |
| PortList |
| Specify a particular port or group of ports. Port numbers are specified with |
| integers between 1 and 4, and should be separated with commas (for lists) or |
| dashes (for ranges). If a portlist is not specified, all physical and virtual ports |
| apply. |
Defaults | Disabled |
Examples | Change IPsecurity 192.0.220.77 Disabled |
| (Restricts the single IP address from the table.) |
| Change IPsecurity 192.0.1.255 Both Disabled |
| (MSS4 only: Restricts all addresses between 192.0.1.0 and 192.0.1.255 from both |
| incoming and outgoing connections.) |
2.26 Change LAT CircTimer
CHANGE LAT CIRCTIMER timerValue
Specifies the delay between messages sent from the MSS to other network nodes. This parameter should not need to be altered, and should not be altered when there are active sessions.
Restrictions | Requires privileged user status. |
Errors | The MSSLite, MSS4, and the |
Parameters | timerValue |
| Specify a value from 30 to 200 milliseconds. |
Defaults | 80 (milliseconds) |
|
