Command Reference | Test |
2.102 Test
TEST PORT PortList
DTR DELAY num 
Tests a serial port’s connection. When the Test command is entered without any parameters, test lines of 70 characters are sent to the specified serial port until a key is pressed.
Restrictions | Nonprivileged users may only test their current port. |
ParametersPort
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s current port only.
PortList
Specify a port number as an integer between 1 and 4. You can not specify more than one port at a time.
DTR
Lowers and then raise the DTR signal on the serial port. If a delay is not specified, DTR will lower for approximately one second and then raise.
Delay
Lowers DTR will for the specified delay length, then raises DTR.
num
Enter a delay time from 50 to 3,000 (milliseconds).
2.103 Zero
ZERO
Resets all counters on the MSS (both serial and Ethernet).
Restrictions | Requires privileged user status. |
