| ACCESSORIES | |
|
|
|
Return to Master TOC
Return to Master TOC
K659-1 GAS GUARD REGULATOR
Adjustable flow regulator with removable adjuster key for CO2 and Argon blend gases. Mounts onto feeder inlet, and reduces gas waste and arc start “blow” by reducing surge caused by excess pressure in supply hose.
Install the
K1556-1 LIGHT DUTY CASTER KIT
This option provides 4 casters and all required hardware to mount it to the Power Feed Wire Feeder.
K1555-2 INSULATED LIFT HOOK
For applications where an insulated lift hook is required. This kit provides an easily installed, heavy duty insulated lift eye that mounts to the wire reel stand mast. See the instructions provided with the kit for installation.
Install per the Instructions shipped with the Kit.
FOOT AMPTROL AMPHENOL
The
The kit is intended for use with the following Cobra Max, Python or Prince XL torches:
Cobra Max |
|
| |
Air Cooled 15ft.(4.5m) |
|
| |
Air Cooled 25ft.(7.6m) |
|
| |
Python |
|
|
|
|
| Water Cooled 15ft.(4.5m) | |
Air Cooled 25ft.(7.6m) | Water Cooled 25ft.(7.6m) | ||
Air Cooled 50ft.(15.6m) | Water Cooled 50ft.(15m) | ||
Prince XL |
|
|
|
|
| Water Cooled 15ft.(4.5) | |
Air Cooled 25ft.(7.6) | Water Cooled 25ft.(7.6) | ||
|
| Water Cooled 50ft.(15.6) | |
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
K1546-1 CONDUIT ADAPTER
Install per the Instructions shipped with the Kit.
This ball bearing equipped incoming bushing can be used in place of the standard incoming wire bushing, when feeding solid steel or cored wire electrodes. It significantly reduces any abrasion to the electrode wire where it enters the feed head. This results in even smoother, more trouble free operation.
CAUTION
Remove all input power to the Power Feed 10M Dual Wire Feeder before installing the Connection Adapter Kit.
WARNING
Refer to the Owner’s Manual of the Torch for Amperage and Duty Cycle rating information. The torch rating may not match the rating of the power source.
MAKING A WELD WITH THE PRINCE XL OR COBRA GOLD TORCH INSTALLED
•Set the idle roll pressure on the wire drive between an indicator reading of
•Depending on the weld mode, set the Voltage or Trim at the Power Feed 10M Dual Wire Feeder using the right control knob located on the upper case front panel.
•The Wire Feed Speed (WFS) is set using the control knob on the Torch. The left control knob on the Power Feed 10M Dual Wire Feeder is inactive. The actual WFS being set at the torch is displayed on the Power Feed 10M Dual Wire Feeder.
•All weld parameters normally available for the active weld mode are available during
