Lincoln Electric SVM172-A service manual Err 001, Err 003, Err 004, Err 005, Err 006

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

F-11 TROUBLESHOOTING & REPAIR F-11

Observe all Safety Guidelines detailed throughout this manual Error Codes for the Power Wave 455: Code 10555 and below

Note: For any Err # listed below write down the error number for reference and try cycling power to see if the error clears itself. If not, refer to the What to Do column for the given Err.

	PROBLEMS	POSSIBLE CAUSE	RECOMMENDED
	(SYMPTOMS)		COURSE OF ACTION
Display shows any of the following:
Err	001	More than 1 CB with the same	Make sure the group dip switch set-
		group number.	ting is unique for each CB.
Err	003	Too many objects in group.	A given group can only support up
			to 7 objects. Remove any objects
			over 7 from the group either by
			changing the group dip switch set-
			tings or physically disconnecting any
			objects over 7 in the group.
Err	004	More than 1 object of the same	Adjust the dip switch setting to make
		equipment type with the same group	either the group # or feed head #
		# and feed head #.	unique for all objects of the same
			equipment type.
Err	005	A feed head has its feed head dip	The appropriate feed head # is 1
		switches set to zero in a group with	through 7. Check the dip switch set-
		more than one object.	ting chart in INSTALLATION section
			and set the switches to make the
			Feed head ID non-zero.
Err	006	Did not receive a recognition com-	Check to see if the status light is not
		mand from the power source.	solid green on the power source
			(refer to status light states in OPER-
			ATION section if not). Also, check
			continuity in the communication lines
			from CB to Power Source (refer to
			wiring diagram). Refer to Power
			source trouble shooting section for
			additional information. If all these
			avenues fail, replace CB mother PC
			board.

CAUTION

If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department at 1-888-935-3877 for electrical troubleshooting assistance before you proceed.

POWER FEED 10M SINGLE/DUAL