
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| OPERATION |
|
|
|
|
CHANGING ARC WAVE CONTROL |
|
|
If the selected weld mode uses any of the four available wave controls, users can press the left MSP4 pushbutton until the ARC CONTROL LED is illuminated. The value, name and units (if applicable) of the available wave con- trols will appear. Note that the name of the control is derived from the weld table and may not necessarily appear as "Wave Control". Repeated pressing of the left MSP4 pushbutton will cycle through all active wave con- trols and then the weld mode. Turning the MSP4 encoder will change the value of the displayed wave control.
CHANGING WELD SEQUENCE BEHAVIOR
Weld sequencing attributes are grouped into two cate- gories, START OPTIONS and END OPTIONS. START OPTIONS may include Preflow Time,
When the Start Time attribute is set to a value other than OFF, the START OPTIONS LED will blink synchronous with the WFS and VOLTS/TRIM LED’s on the
INFRARED (IR) CONTROL
The MSP4 interface includes an infrared transceiver. This allows wireless machine configuration using a Palm OS based hand held computer. A proprietary Palm OS appli- cation, ALPalm, was developed for this purpose. (Contact Lincoln Electric for more information on this feature.)
LOCKOUT/SECURITY
The MSP4 can be optionally configured to prevent the welder from changing selected MSP4 options. By default, the welder will be able to change the weld mode, all rele- vant wave controls and all relevant start and end options.