
CONFIG Commands
☛NOTE:
A filterset can only be configured for the bridge if the system bridge or concur- rent bridging/routing is enabled.
set bridge ethernet option { on off }
Enables or disables bridging services for the specified virtual circuit using Ethernet fram- ing.
set bridge dsl vccn option { on off }
Enables or disables bridging services for the specified interface. Specified interface must be part of a VLAN if bridge is turned on. Only
•show log command will show that WAN Bridge is enabled when at least one WAN inter- face is bridged.
•show ip interfaces and show bridge interfaces commands will show the interfaces that are not in bridged mode and that are in bridged modes, respectively.
set bridge table-timeout [ 30 ... 6000 ]
Sets the timeout value for bridging table timeout. Default = 30 secs; range = 30 secs – 6000 secs