Motorola 7.7.4 manual Remote ATA Configuration Commands

CONFIG Commands

CONFIG Commands

This section describes the keywords and arguments for the various CONFIG commands.

Remote ATA Configuration Commands

Motorola Netopia® firmware supports configuration of a maximum of four Motorola Neto- pia® ATA profiles, which are stored in the Gateway’s configuration database. When a Motorola Netopia® ATA is discovered, the Gateway compares the MAC address of the ATA with one of the existing profiles stored in the database. If there is a match, the configura- tion is downloaded to the Motorola Netopia® ATA, and the ATA is restarted. Once the Motorola Netopia® ATA is restarted, it comes up with the newly downloaded configuration.

set ata profile [ 0... 3 ] ata-option [ on off ]

Enables or disables the remote ATA configuration option for the specified ATA configuration profile to be stored in the Gateway.

set ata profile [ 0... 3 ] ata-mac-addr MAC_addr

Specifies the MAC address of the ATA for the specified configuration profile.

set ata profile [ 0... 3 ] ata-qos-enable [ on off ]

Enables or disables QoS for the specified profile.

set ata profile [ 0... 3 ] ata-dhcpc-enable [ on off ]

Enables or disables DHCP client service for the specified profile.

set ata profile [ 0... 3 ] ata-dhcpc-hostname string

Specifies a DHCP client hostname for the specified profile.

set ata profile [ 0... 3 ] ata-dhcpc-vid-enable [ off on ]

Enables or disables a DHCP client vendor ID for the specified profile.

191