Motorola 7.7.4 manual Set security ipsec tunnels name, 257

CONFIG Commands

set security ipsec tunnels name "123"

The name of the tunnel can be quoted to allow special characters and embedded spaces.

set security ipsec tunnels name "123" tun-enable (on) {on off}

This enables this particular tunnel. Currently, one tunnel is supported.

set security ipsec tunnels name "123" dest-ext-addressip-address

Specifies the IP address of the destination gateway.

set security ipsec tunnels name "123" dest-int-network ip-address

Specifies the IP address of the destination computer or internal network.

set security ipsec tunnels name "123" dest-int-netmask netmask

Specifies the subnet mask of the destination computer or internal network. The subnet mask specifies which bits of the 32-bit IP address represents network information. The default subnet mask for most networks is 255.255.255.0 (class C subnet mask).

set security ipsec tunnels name "123" encrypt-protocol (ESP) { ESP none }

See page 94 for details about SafeHarbour IPsec tunnel capability.

set security ipsec tunnels name "123" auth-protocol (ESP) {AH ESP none}

See page 94 for details about SafeHarbour IPsec tunnel capability.

set security ipsec tunnels name "123" IKE-mode pre-shared-key-type (hex) {ascii hex}

See page 94 for details about SafeHarbour IPsec tunnel capability.

257