Motorola 7.7.4 manual Set vlan name name ports port tag off on

CONFIG Commands

set vlan name name ports port tag [ off on ]

If set to on, packets transmitted from this port through this VLAN must be tagged with the VLAN VID. Packets received through this port destined for this VLAN must be tagged with the VLAN VID by the source. The tag option is only available on global type ports.

set vlan name name ports port priority [ off on ]

Enables or disables the priority for the port assigned to the specified VLAN allowing packet prioritization based on any 802.1p priority bits in the VLAN header to prioritize pack- ets within the Gateway’s internal queues, according to DiffServ priority mapping rules.

set vlan name name ports port promote [ off on ]

Enables or disables the promote setting allowing writing any 802.1p priority bits into the IP-TOS header bit field for received IP packets on this port destined for this VLAN. Write any IP-TOS priority bits into the 802.1p priority bit field for tagged IP packets transmitted from this port for this VLAN. All mappings between Ethernet 802.1p and IP-TOS are made via diffserv dscp-mapsettings.

set vlan name name ports port port-pbits [ 0 - 7 ]

Specifies the 802.1p priority bit for this port associated with the specified VLAN. If you set this to a value greater than 0, all packets of this port with unmarked priority bits (pbits) will be re-marked to this priority.

set vlan name name ip-interface ip_interface

Associates this VLAN with the specified IP interface. By default the ip-vcc1and ip-eth-ainterfaces are available, but others may be defined.

set vlan name name inter-vlan-routing [ group-1... group-8 ] [ off on ]

When set to on, inter-vlan-routingallows VLANs in the specified group to route traffic to the others; ungrouped VLANs cannot route traffic to each other.

You must save the changes, exit out of configuration mode, and restart the Gateway for the changes to take effect.

289