Motorola 7.7.4 manual 238

set ip static-routesdestination-networknet_address netmask netmask

Specifies the subnet mask for the IP network at the other end of the static route. Enter the netmask argument in dotted decimal format. The subnet mask associated with the desti- nation network must represent the same network class (A, B, or C) or a lower class (such as a class C subnet mask for class B network number) to be valid.

set ip static-routes destination-network net_address interface { ip-address ppp-vccn }

Specifies the interface through which the static route is accessible.

set ip static-routes destination-network net_address gateway-address gate_address

Specifies the IP address of the Gateway for the static route. The default Gateway must be located on a network connected to the Motorola Netopia® Gateway configured interface.

set ip static-routes destination-network net_address metric integer

Specifies the metric (hop count) for the static route. The default metric is 1. Enter a num- ber from 1 to 15 for the integer argument to indicate the number of routers (actual or best guess) a packet must traverse to reach the remote network.

You can enter a metric of 1 to indicate either:

•The remote network is one router away and the static route is the best way to reach it;

•The remote network is more than one router away but the static route should not be replaced by a dynamic route, even if the dynamic route is more efficient.

set ip static-routes destination-network net_address

rip-advertise [ splitHorizon always never ]

Specifies whether the gateway should use Routing Information Protocol (RIP) broadcasts to advertise to other routers on your network and which mode to use. The default is splitHo- rizon.

238