CONFIG Commands

set security state-insp udp-timeout [ 30 - 65535 ]

Sets the stateful inspection UDP timeout interval, in seconds.

set security state-insp dos-detect [ off on ]

Enables or disables the stateful inspection Denial of Service detection feature. If set to on, the device will monitor packets for Denial of Service (DoS) attack. Offending packets may be discarded if it is determined to be a DoS attack.

set security state-insp xposed-addr exposed-address# "n"

Allows you to add an entry to the specified list, or, if the list does not exist, creates the list for the stateful inspection feature. xposed-addrsettings only apply if NAT is off.

Example:

set security state-insp xposed-addr exposed-address# (?): 32

32 has been added to the xposed-addrlist.

Sets the exposed list address number.

set security state-insp xposed-addr exposed-address# "n" start-ip ip_address

Sets the exposed list range starting IP address, in dotted quad format.

set security state-insp xposed-addr exposed-address# "n" end-ip ip_address

Sets the exposed list range ending IP address, in dotted quad format.

32 exposed addresses can be created. The range for exposed address numbers are from 1 through 32.

set security state-insp xposed-addr

263

Page 263
Image 263
Motorola 7.7.4 manual Set security state-insp udp-timeout 30, Set security state-insp dos-detect off on, 263