CONFIG Commands
remote network. If you specify ppp, the Motorola Netopia® unit uses the default gateway being used by the remote PPP peer.
☛NOTE:
For a DSL platform you must identify the virtual PPP interface [vccn], a num- ber from 1 to 8.
set ip ip-ppp [vccn] option { on off }
Enables or disables IP routing through the virtual PPP interface. By default, IP routing is turned on. If you turn off IP routing and save the new configuration, the Motorola Netopia® Gateway clears IP routing settings
set ip ip-ppp [vccn] address ip_address
Assigns an IP address to the virtual PPP interface. If you specify an IP address other than 0.0.0.0, your Motorola Netopia® Gateway will not negotiate its IP address with the remote peer. If the remote peer does not accept the IP address specified in the ip_address argument as valid, the link will not come up.
The default value for the ip_address argument is 0.0.0.0, which indicates that the vir- tual PPP interface will use the IP address assigned to it by the remote peer. Note that the remote peer must be configured to supply an IP address to your Motorola Netopia® Gate- way if you enter 0.0.0.0 for the ip_address argument.
set ip ip-ppp [vccn] peer-address ip_address
Specifies the IP address of the peer on the other end of the PPP link. If you specify an IP address other than 0.0.0.0, your Motorola Netopia® Gateway will not negotiate the remote peer's IP address. If the remote peer does not accept the address in the ip_address argument as its IP address (typically because it has been configured with another IP address), the link will not come up.
