Motorola 7.7.4 manual Qos off assure expedite network-control, 228

set diffserv custom-flows name name protocol [ TCP UDP ICMP other ] direction [ outbound inbound both ] start-port [ 0 - 65535 ]

end-port [ 0 - 65535 ] inside-ipinside-ip-addr inside-ip-maskinside-ip-netmask outside-ipoutside-ip-addr outside-ip-maskoutside-ip-netmask

qos [ off assure expedite network-control ]

Defines or edits a custom flow. Select a name for the custom-flow from the set command. The CLI will step into the newly-named or previously-defined flow for editing.

•protocol – Allows you to choose the IP protocol for the stream: TCP, UDP, ICMP, or other.

other is appropriate for setting up flows on protocols with non-standard port definitions, for example, IPSEC or PPTP. If you select other, an additional field, numbered-proto- col will appear with a range of 0–255. Choose the protocol number from this field.

•direction – Allows you to choose whether to apply the marking and gateway queue behavior for inbound packets, outbound packets, or to both. If the Gateway is used as an “edge” gateway, its more important function is to mark the packets for high-priority streams in the outbound direction.

•start-port/end-port– Allows you to specify a range of ports to check for a particular flow, if the protocol selection is TCP or UDP.

•inside-ip/mask– If you want packets originating from a certain LAN IP address to be marked, enter the IP address and subnet mask here. If you leave the address equal to zero, this check is ignored for outbound packets. The check is always ignored for inbound packets. The DiffServe queuing function must be applied ahead of NAT; and, before NAT re-maps the inbound packets, all inbound packets are destined for the Gate- way's WAN IP address.

•outside-ip/mask– If you want packets destined for and originating from a certain WAN IP address to be marked, enter this address and subnet mask here. If you leave the address equal to zero, the outside address check is ignored. For outbound flows, the outside address is the destination IP address for the packets. For inbound packets, the outside address is the source IP address for the packets.

Note:

When setting the Inside/Outside IP Address/Netmask settings, note that a netmask value can be used to configure for a network rather than a single IP address.

228