Motorola MVME187 manual This will be the local bus address

A

Configure and Environment Commands

Table A-1. ENV Command Parameters (Continued)

ENV Parameter and Options	Default	Meaning of Default
Master Enable #4 [Y/N]	N	Do not set up and enable the Master
		Address Decoder #4.
Master Starting Address #4	00000000	Base address of the VMEbus resource
		that is accessible from the local bus.
		This will be the local bus address.
		Default is $0.
Master Ending Address #4	00000000	Ending address of the VMEbus
		resource that is accessible from the
		local bus. This will be the local bus
		address. Default is $0.
Master Address Translation	00000000	This register will allow the VMEbus
Address #4		address and the local address to be
		different. The value in this register is
		the base address of the VMEbus
		resource that is associated with the
		starting and ending address selection
		from the previous questions. Default
		is $0.
Master Address Translation Select	00000000	This register deÞnes which bits of the
#4		Translation Address are signiÞcant. A
		logical one "1" indicates signiÞcant
		address bits, logical zero "0" is non-
		signiÞcant. The non-signiÞcant bits
		will come from the local bus address
		that accesses the VMEbus. Normally
		MS bits will be set, down to the size of
		memory to be accessed.Default is $0.
Master Control #4	00	Works the same as Slave Control #1.
		Default is $00.
Short I/O (VMEbus A16) Enable	Y	Yes, Enable the Short I/O Address
[Y/N]		Decoder.
Short I/O (VMEbus A16) Control	01	Works the same as Slave Control #1.
		Default is $01.

A-12