Motorola MVME187 manual Env Return, St Return, De Return

	Table D-1. Troubleshooting Steps (Continued)
Condition		Possible	Try This:
		Problem
			6. You may need to use the cnfg command (see
			Appendix A) to change clock speed and/or
			Ethernet Address, and then later return to
			env <Return>
			and step 3.
			7. Run selftest by typing in
			st <Return>
			The tests take as much as 10 minutes, depending
			on RAM size. They are complete when the
			prompt returns. (The onboard selftest is a
			valuable tool in isolating defects.)
			8. The system may indicate that it has passed all the
			selftests. Or, it may indicate a test that failed. If
			neither happens, enter
			de <Return>
			Any errors should now be displayed. If there are
			any errors, go to step VI. If there are no errors, go
			to step V.
V. The debugger		A. No problems.	No further troubleshooting steps are required.
is in system		Troubleshooting
mode and the		is done.	Note Even if the board passes all tests, it may
board auto
boots, or the			still be bad. Selftest does not try out all
board has			functions in the board (for example,
passed selftests.			SCSI, or VMEbus tests).
VI. The board		A. There may be	1. Document the problem and return the board for
has failed one or		some fault in	service.
more of the tests		the board	2. Phone 1-800-222-5640.
listed above, and		hardware or the
can not be		on-board
corrected using		debugging and
the steps given.		diagnostic
		Þrmware.

YOU ARE FINISHED (DONE) WITH THIS TROUBLESHOOTING PROCEDURE.

D

D-5