
Functional Description
Front Panel Switches and LEDs
There are two switches and eight LEDs on the boardÕs front panel (refer to Table
Table 2-3. Front Panel Switches
Switch | Description | |
Name | ||
| ||
|
| |
RESET | The RESET switch resets all onboard devices and drives SYSRESET* if the | |
board is system controller. The RESET switch may be disabled by software. | ||
| ||
|
| |
| When enabled by software, the ABORT switch generates an interrupt at a user- | |
ABORT | programmable level. It is normally used to abort program execution and | |
| return to the debugger. | |
|
|
2 |
|
| Table | |
|
|
| |
LED | Color | Description | |
Name | |||
|
| ||
|
|
| |
FAIL | Red | The FAIL LED lights when the BRDFAIL signal line is active. | |
|
|
| |
STAT | Yellow | The STAT LED is controlled by software on the MVME187. | |
|
|
| |
RUN | Green | The RUN LED lights when the local bus TIP* signal line is low. This | |
indicates one of the local bus masters is executing a local bus cycle. | |||
|
|
| |
SCON | Green | The SCON LED lights when the MVME187 is the VMEbus system | |
controller. | |||
|
|
| |
LAN | Green | The LAN LED lights when the LAN chip is local bus master. | |
|
|
| |
+12V | Green | The +12V LED lights when +12V power is available to the Ethernet | |
transceiver interface. | |||
|
|
| |
SCSI | Green | The SCSI LED lights when the SCSI chip is local bus master. | |
|
|
| |
|
| The VME LED lights when the board is using the VMEbus (VMEbus | |
VME | Green | AS* is asserted by the VMEchip2) or when the board is accessed by | |
|
| the VMEbus (VMEchip2 is the local bus master). | |
|
|
|