DATA PROGRAMMING

Assignment of FCH Related Data

STEP 1: ANPDN/ANPDL Note

Assign the first digit of the LCR/LCRS access code. When the access code is common to all nodes, use the ANPDN command. When the access code is assigned for each node, use the ANPDL com- mand.

TN=1

1st DC=8

CI=N (Normal)

NND=1

TN=1

1st DC=8

CI=H (Hooking)

NND=1

STEP 2: ASPAN/ASPAL Note

Assign the LCR/LCRS access code for a dummy route number. When the access code is common to all nodes, use the ASPAN command. When the access code is assigned for each node, use the ASPAL command.

ACC=8

CI=N (Normal)

SRV=LCR/LCRS

LGRT=Dummy route number

ACC=8

CI=H (Hooking)

SRV=LCR/LCRS

LGRT=Dummy route number

STEP 3: AMND

 

 

 

Using AMND, assign the Maximum Necessary Digits to be received by Register (ORT) circuit.

DC=8110 MND=8

STEP 4: ARNPL

Using ARNPL, assign the access code for each external trunk route, but not for a dummy route.

RT=10 ACC=8

RT=200 ACC=9

Note: When entering the data in STEP 1, 2, 6, 7 and 8, do not mix the commands for LDM and NDM. Write the data on the same data memory as shown below:

When writing the data on the LDM:

ANPDL

ASPAL

AFRSL

AOPRL

AADCL

(STEP 1)

(STEP 2)

(STEP 6)

(STEP 7)

(STEP8)

When writing the data on the NDM:

ANPDN

ASPAN

AFRSN

AOPRN

AADCN

(STEP 1)

(STEP 2)

(STEP 6)

(STEP 7)

(STEP8)

ND-70185 (E)CHAPTER 5

Page 91

Revision 3.0

Page 106
Image 106
NEC NEAX2400 system manual ACC=8, Srv=Lcr/Lcrs, Amnd, Arnpl