NEC NEAX2400 system manual Installation

INSTALLATION

Connecting Cables

Figure 4-15shows some typical examples, where 10 BASE-T cables are connected to the FCH card(s) mounted in PIM2 of 1-IMG system, under the following conditions:

	Configuration	Configuration	Used Cable Unit			Number of HUB/
	of CPU	of LAN	(Note 1, Note 2)				FCH
Pattern 1	Single	Single	SR1201 ETIF CAU-C ⋅	1		HUB⋅	1, FCH⋅	1
Pattern 2	Dual	Single	SR1201 ETIF CAU-C ⋅	1		HUB⋅	2, FCH⋅	2
			SR1201 ETIF CAU-DC	⋅	1
Pattern 3	Single	Dual	SR1201 ETIF CAU-C ⋅	2		HUB⋅	2, FCH⋅	2
Pattern 4	Dual	Dual	SR1201 ETIF CAU-C ⋅	2		HUB⋅	2, FCH⋅	2
			SR1201 ETIF CAU-DC	⋅	2

Note 1: Cables contained in each cable unit are as follows.

SR1201 ETIF CAU-C: UTP CTG5 ST CA-M, UTP CTG5 ST CA-J

SR1201 ETIF CAU-DC: UTP CTG5 ST CA-K, UTP CTG5 ST CA-J, UTP CTG5 CRS CA-F

Note 2: The cables cited in Figure 4-15can be used in the 1-IMG system only. Refer to Page 45 through Page 48 for more details.

HUB (PA-M96) FCH (PA-FCHA)

ATTENTION

Connectors for 10 BASE-T

							Contents
							Static Sensitive
							Handling
			<FCH in PIM2 (Pattern 1)>		<FCH in PIM2 (Pattern 2)>		Precautions Required
CN	= 10 BASE-T Connector
Use 10 BASE-T connectors.
				TOPU			TOPU
	TP7-X	10 BASE-T
	TP6-X
	TP5-X
	TP4-X
	TP3-X			PIM 3			PIM 3
	TP2-X
	TP1-X
	TP0-X
							UTP CTG5 ST CA-K
	FRONT VIEWI		CN	PIM 2	CN	CN	PIM 2
			FCH		FCH	FCH
			FANU			FANU

PIM 1		PIM	1
	UTP CTG5 ST CA-M

CN	CN		CN
UTP CTG5 ST CA-M	CN		CN	PIM 0
	PIM 0
CN	CN	UTP CTG5 CRS CA-F	CN
HUB
	HUB		HUB
00 0102 03 04 05 06		00 0102 03 04 05 06
	BSCM			BSCM
UTP CTG5 ST CA-J		CN
	LPM	02 03 04 05 06LPM
00 0102 03 04 05
		UTP CTG5 ST CA-J
CN		CN
BASEU		BASEU

Figure 4-15 Examples of Ethernet Cable Connection-FCH in PIM2 (1-IMG System) (1/2)

CHAPTER 4 ND-70185 (E)

Page 52

Revision 3.0