DATA PROGRAMMING
Network Data Programming Summary
1.Network Data Programming Summary
This section explains a summary of the data programming of Fusion systems.
1.1
To install the Fusion network as a
1.1.1System Data
•Decide an NCN, and LN on the network.
•Assign System Data for each node. Use the ASYDN command for the NCN and the ASYDL com- mand for all nodes. The system data includes the size of LDM, NDM, Fusion Point Code (FPC), etc.
Note: The data becomes effective by executing
•Assign unit data using the AFMU command for each node which exists on the network. Note that the AFMU command is available at NCN only.
•Assign Logical Route Numbers for all routes (external trunk) on the network using the ALRTN command. Note that the ALRTN command is available at NCN only.
1.1.2Numbering Plan Data
•ANPDN → ASPAN (for NCN only): Assign numbering plan data for Telephone Number.
•ANPDL → ASPAL (for NCN and LN): Assign numbering plan data for Service Codes, Trunk Ac- cess Codes, etc. other than STN (physical station) and TELN.
•ANPD → ASPA (for NCN and LN): Assign numbering plan data for Physical Station Number using STN.
Note: The Numbering Plan data for the LDM and/or NDM cannot use separate Tenant Numbers (TN). Therefore, be sure to assign the following data on the ASYDL command.
•ASYDL command, SYS1, INDEX 800
b1 = 1 (ASPAL command tenant data table development on LDM = Common)
b2 = 1 (ANPDL command tenant data table development on LDM = Common)
1.1.3Station Numbering
•Assign Telephone and/or Physical Station Numbers using the following command: ALGNN → ALGSN: Assign Telephone Number on the network. (NCN only)
ASDT: Assign Physical Number for each node as required. (available for NCN and LN)
1.1.4Fusion Link Data
•Assign the Fusion Link data using the following commands:
Fusion with FCH:ACRD → | ACTK → | ACAN → | MBCT → AFCH → | AFPC → AFRT |
Fusion w/o FCH:ACRD → | ACTK → | ACAN → | MBCT → | AFPC |
CHAPTER 5 |
Page 58
Revision 3.0
