NEC NEAX2400 system manual Replace the handset of STN A

POST INSTALLATION TEST

Fusion and Non-Fusion Connection Tests

4.1 When Seizing a Trunk from a Station

Check

STEP 1: Using the MAT command, make busy all trunks in the route except the trunk to be tested.

STEP 2: Station A in self-node (Node A) dials the Physical Station Number for Station B in Node C.

STEP 3: The call terminates to Station B via FCCS and non-FCCS.

STEP 4: Confirm the speech condition is sufficient (no noise, not one-way speech, etc.).

STEP 5: Replace the handset of STN A.

STEP 6: Repeat the above steps for all Fusion links.

Check

4.2 When Seizing a Trunk from an ATTCON

STEP 1: The operator at the ATTCON in Self-Node (Node A) dials Physical Station Number for Station B in Node C.

STEP 2: The call terminates to Station B via FCCS and non-FCCS.

STEP 3: Confirm the speech condition is sufficient (no noise, not one-way speech, etc.)

STEP 4: The operator at the ATTCON releases the call by pressing the CANCEL key.

Node A (Self-Node)	Node B	Node C
LC		LC
FCCS		Non-FCCS
STN A￿		STN B￿
TELN: 410000￿		TELN: 420000￿
STN: 2000		STN: 2000
ATI
ATTCON

Figure 6-13 CCIS-FCCS Outgoing Call Test

CHAPTER 6 ND-70185 (E)

Page 144

Revision 3.0