NEC NEAX2400 system manual Mbtc, Adpc, Acsc, Cscg Cicg

EX- FCCS

Data Programming

STEP 4: MBTC

Assign IDLE status of trunks by designating Route Number and Trunk Number.

STEP 5: ADPC

Assign the destination PC (Point Code) on RT (for speech path) number basis for all the nodes in the EX-FCCS network.

STEP 6: ACSC

Assign the location of the CCH in CSCG (Common Channel Signaling Controller Group).

Assign thue location of the CCH using the ACSC command. The following is sample data assignment. In this sample, PC 3 is equipped with three DTI cards. Note that if the system employs one CCIS link, enter the same data in CSCG130 and CSCG131.

CSCG	MG	U	G	CICG
	AA	A	AA	0
	BB	B	BB	1
130	BB	B	BB	2
	BB	B	BB	3
(Basic/
Primary	BB	B	BB	4
Route)
	BB	B	BB	5
	BB	B	BB	6
	BB	B	BB	7

CCH 0

CCH 1

CSCG	MG	U	G	CICG
	CC	C	CC	0
	CC	C	CC	1
	CC	C	CC	2
131
	CC	C	CC	3
(Alternate					CCH 2
	CC	C	CC	4
Route)
	CC	C	CC	5
	CC	C	CC	6
	CC	C	CC	7

Note 1: In the case of actual data entry, enter corresponding LEN numbers instead of letters such as “AAAAA”.

Note 2: Refer to Figure 8-8“Port Allocation and Related Command for CCIS Trunk”.

CHAPTER 8 ND-70185 (E)

Page 188

Revision 3.0