
EX- FCCS
Data Programming
1.To Log-in to All Nodes in EX-FCCS Network
To upgrade CCIS network to
STEP 1: AFUGN
Assign
STEP 2: AEXFN
Assign the CCH Selection Data by designating all the Fusion Point Code (FPC) and the Point Code (PC) in the connected Fusion Group.
Note: Confirm the Centralized MAT can log in to each node here. Reexamine the assigned data if
2.To Access to EX-FCCS Trunk via EX-FCCS Telephone Number
Assign the following data to activate originating calls via
<All the nodes consist of IMX system>
AEADN: Assign the ADC (Abbreviate Digit Code) for connection Fusion Group. Enter the FUG Number as- signed by AFUGN command, TN, and ADC to be assigned.
<NCN of the Center FUG>
AELGN: Telephone Numbers must be assigned for all the station within the network uniquely. Use AELGN command to allocate
Only readout function can be used by this command in case both the Self FUG Number and the Con- nection FUG Number are assigned, if the Self FUG is not the Center FUG.
Note 1: Refer to the service feature manual for NEAX2000 IVS2 system as to the data programming on NEAX2000 IVS2 side.
Note 2: Check whether the trunk originating call via CCIS can be executed by dialing
ND-70185 (E)CHAPTER 8
Page 197
Revision 3.0