EX- FCCS
5.Up to a maximum of 120,000 Telephone Numbers may be assigned in the entire Enhanced CCIS/EX- FCCS network (including Telephone Numbers in the NEAX2000 IVS2) and a maximum of 48,000
per FUG (not to exceed 120,000 per total network).
3.2
[Centralized Maintenance]
(a) NEAX2000 IVS2
1.MAT software for NEAX2400 IMX system and NEAX2000 IVS2 system are installed on a PC called the “MAT.” Depending on the system logged into determines the MAT software used.
2.To log in the NEAX2000 IVS2 system, Point Code of the system is designated.
3.See the manual describing NEAX2000 IVS2 for the method of checking the
4.The data transmission speed between NEAX2000 IVS2 and NEAX2400 IMX may be a maximum of 64Kbps since the CCH card is used.
(b) NEAX2400 IMX
1.All systems in the
2.To log in to the NEAX2400 IMX system, assign FUG no. to designate the desired Fusion Network Group (FUG) and FPC to designate the desired node in the FUG.
3.The user ID and password written in the NDM of each FUG is checked when logging into the NEAX2400 IMX. This data is programmed using the AUIDN command.
4.When any of the conditions below are met, the MAT is logged into the node designated by the FPC, but within the FUG where the MAT is installed regardless of entered FUG no. data.
•No data is assigned to SELF_ FUG (Fusion Group number in the
•FUG requested by the MAT is 0
•FUG requested by the MAT is the FUG number of
5.The existing system (not NEAX2400 IMX) can not be maintained via the
6.Time required for transmitting the 1Mbyte data (1 block of DM) is 2 hours at 64Kbps data speed/1 hour at 128Kbps data speed/15 minutes at 512Kbps data speed.
Note: The number of MAT to be installed may vary depending on the customer specification (one or two MAT can be used to centralize the MAT operation or three or more MATs can be used to separate the MAT operation).
Page 177
Revision 3.0
