NEC NEAX2400 system manual Assignment of FCH Related Data

DATA PROGRAMMING

Assignment of FCH Related Data

STEP 4: MBCT

Unbusy the connection trunk data assigned in the previous step using MBCT (Make Busy of Connec- tion Trunk) command. This step is required for both B-channel and D-channel trunk. The MBCT command should look similar to the following.

MBCT (Make Busy of Connection Trunk Data)

MBCT (Make Busy of Connection Trunk for Local)

C_RT	C_TK
1	5
MB
0
WRT?
Y

C_RT: 1-1023￿

C_TK: 1- 4095

Make Busy Information￿

0:Make Idle￿

1:Make Busy (Outgoing)

Figure 5-26 MBCT Command Display

7.Assignment of FCH Related Data

STEP 1: For Fusion with FCH only:

•Assign FCH Number on an FCH (PA-FCHA) circuit card basis.

•The FCH Number must conform to the following conditions:

•FCH Number range must be between 1 and 255.

•At the network level, the same FCH Numbers can be assigned. However, they must be unique at the node level.

•Use sequential numbers starting from 1 as FCH Numbers.

ND-70185 (E)CHAPTER 5

Page 81

Revision 3.0