NEC NEAX2400 system manual Assign the following data at NCN of the FUG

EX- FCCS

Data Programming

2.To Access EX-FCCS Trunk via EX-FCCS Telephone Number

Assign the following data at NCN of the FUG.

STEP 1: AEADN

Assign the ADC (Abbreviate Digit Code) for connection Fusion Group. Enter the FUG Number as- signed by AFUGN command, TN, and ADC to be assigned.

STEP 2: AELGN

Telephone Numbers must be assigned for all the station within the network uniquely. Use AELGN command to allocate EX-FCCS Telephone Number. FUG data must be assigned previously by AFUGN command to activate this command.

Only readout function can be used by this command in case both the Self FUG Number and the Con- nection FUG Number are assigned, if the Self FUG is not the Center FUG.

Note 1: Check whether the trunk originating call via CCIS can be executed by dialing EX-FCCS Telephone Number here. Reexamine the assigned data if the call cannot be connected. There may be some error in data setting so far.

Note 2: Refer to the service feature manual for NEAX2000 IVS2 system as to the data programming on NEAX2000 IVS2 side.

4.2.3Upgrading CCIS Network including IVS2 System to EX-FCCS Network

FUG2

IMX

PC2

NCN2

CCIS

Enhanced

CCIS

CCIS

CCIS

FUG3

IMX

PC3

NCN3

	IVS2 System
FUG1		PC4
(Center FUG)

IMX	Enhanced
	CCIS
PC1
NCN1
	Enhanced
Enhanced	CCIS
CCIS

PC5

IVS 2 System

CHAPTER 8 ND-70185 (E)

Page 196

Revision 3.0