NEC NEAX2400 system manual Actk, Example

C_RT: Connection Route (1-1023)￿

C_TK: Connection Trunk (1-4095)￿

C_LENS: Connection Line Equipment Numbers

DATA PROGRAMMING

Assignment of Telephone Numbers

STEP 2: ACTK

Assign the connection trunk data of both B-channel and D-channel using the ACTK command. As- sign the Connection Equipment Number (C_LENS) referring to Figure 5-22through Figure 5-25. The ACTK command display should ￿look similar to the following.

ACTK (Assignment of Connection Trunk Data for Local Data Memory)

C_RT C_TK

10

1

C_LENS

000010

WRT?

Y

Figure 5-22 ACTK Command Display (example)

The mounting location of the FCH, DTI cards can be classified into the following two types.

Regular Density Slot (16-port slot) -See Figure 5-23.

High Density Slot (32-port slot) -See Figure 5-24and Figure 5-25.

6.1.1When FCH is mounted in a Extended Density Slot

If the FCH is to be mounted in the Extended Density Slot, the connection trunk should be assigned as shown in the figures below. If the card’s mounting location is in any of the Slot Nos. 04, 06, 08, or 15, 17, 19, the following extended Group should be used for the Dch trunk: G27, 29, or 31. Figure 5-23shows an example where the cards are mounted in density Slots 04 or 05.

00	02	04	05	06	07	08	09	10	11	12	13	14 15	16	17	18	19	20	21	22	23
example
				05	07 09		11	15	19	23		01	03	05	07	09	11	15	19	23
PWR	DPWR							14	18	22	TSW/MUX	TSW/MUX						14	18	22	PIM
								13	17	21								13	17	21
				04	06	08	10					00	02	04	06	08 10
								12	16	20								12	16	20
				16 Port					32 Port					16 Port					32 Port
								FRONT VIEW

Figure 5-23 Mounting FCH and DTI Cards in Regular Density Slots

CHAPTER 5 ND-70185 (E)

Page 76

Revision 3.0