NEC NEAX2400 system manual Fccs Network Connection Test

POST INSTALLATION TEST

FCCS Network Connection Test

Make sure that the LYR LED flashes at 60-INT.
				FCH (PA-FCHA) card
When the result of test￿
is OK, the LYR LED￿				MB
flashes.
LYR	Flash
		EST3 Send		MNT
Remains ON￿	LB		Receive Polarity of￿	Mode 8
when available￿		EST2	pair-wire is normal
for Ethernet		EST1	Receive
				DTI
		EST0	Link is￿
			established
Remains ON￿LOAD				FCH
when ready to broadcast￿		Front View
data packets	Note
				Front View

Note: When the FCH is a “Root Bridge”, the LOAD LED remains ON.

Figure 6-7 Fusion Link-Test Results

STEP 4: Return Mode to 8 (standard setting) when the test is complete.

STEP 5: Initialize the FCH (PA-FCHA) card using the MB switch.

Note: Be sure to initialize the FCH (PA-FCHA) card, after changing the setting of the Mode Switch.

3.FCCS Network Connection Test

This section explains how to perform the following connection tests within the Fusion network:

•Station-to-Station Connection Test (via FCCS)

•ATTCON Connection Test (via FCCS)

•Line (LC, ELC, DLC card) Connection Test (via FCCS)

•3-party Conference Trunk Function Test (via FCCS)

3.1Station-to-Station Connection Test (via FCCS)

Perform the station-to-station connection test, following the procedure listed below.

Check

3.1.1 FCCS Call Origination Test

STEP 1: Using the MBCT command, make busy all trunks in the route except the trunk to be tested.

STEP 2: Lift the handset of STN A in Node A.

STEP 3: Dial a Telephone Number (STN B) which belongs to another node.

CHAPTER 6 ND-70185 (E)

Page 138

Revision 3.0