DATA PROGRAMMING
Assignment of FCH Related Data
STEP 5: ARTD/ARTDN
Using ARTD, assign the following CDN data for the dummy route number. Note 1
CDN 6 (TCL)=1 or 4 (depending on requirement)
CDN 7 (L/T)=1
CDN 13 (AC)=1
The other CDNs may be left default (data 0) for the dummy route.
STEP 6: AFRSL/AFRSN Note 2
Using AFRSL, assign the Number Pattern Code (NPC) and the Outgoing Route Selection Pattern Number (OPR) for the dummy route number.
LGRT=Dummy route number | NPC=8110 | OPR=1 |
STEP 7: AOPRL/AOPRN Note 2 |
|
|
Using AOPRL, assign the external route number to OPR assigned in the AFRSL command.
TDPTN=0 | OPR=1 | RA=0 | E=1 | LGRT=10 | SKIP=4 | PNL=0 | OVFT=0 |
PRSC=0 |
|
|
|
|
|
|
|
TDPTN=0 | OPR=1 | RA=1 | E=0 | LGRT=200 | SKIP=8 | PNL=128 | OVFT=0 |
PRSC=0 |
|
|
|
|
|
|
|
STEP 8: AADCL/AADCN Note 2
Using AADCL, assign the additional Digit Code to PNL assigned in the AOPRL command.
PNL=128
DC=12025678901
STEP 9: ARSCN
Using ARSCN, assign the Route Restriction Class (RSC) that allows RRIs for the external trunk route. The same route restriction data must be assigned for each node.
Note 1: The dummy route must be assigned to all nodes (including a node which does not have external routes).
Note 2: When entering the data in STEP 1, 2, 6, 7 and 8, do not mix the commands for LDM and NDM. Write the data on the same data memory as shown below:
•When writing the data on the LDM:
ANPDL → | ASPAL → | AFRSL → | AOPRL → | AADCL |
(STEP 1) | (STEP 2) | (STEP 6) | (STEP 7) | (STEP8) |
•When writing the data on the NDM:
ANPDN → | ASPAN → | AFRSN → | AOPRN → | AADCN |
(STEP 1) | (STEP 2) | (STEP 6) | (STEP 7) | (STEP8) |
CHAPTER 5 |
Page 92
Revision 3.0